Home > News > Content

Reduction Gearbox Maintenance For Operation

Mar 11, 2024

1. Manufacturing of spare parts
The reduction gear box need to inspected and overhauled on a regular basis. If abrasion, gluing, or substantial parts, effective measures need to implemented. Spare parts need to under the standard. and following run-in and load testing, the updated spare parts need to used officially.


2.Examining two transmissions
Regular inspections and maintenance need required for reduction gearboxes. Effective measures required since abrasion, gluing, and significant wear have been found. Before being officially used, updated spare parts should undergo load testing . and run-in testing in accordance with the standard.


3.Oil quantity and oil temperature
Check the tightness of the bolts and the oil quantity frequently. The oil level lower than the lower scale line of the vernier scale need to replenished in time. Circulating oil lubrication should pay attention to the change of oil pressure. when the oil pressure is significantly lower, should check and clean the oil filter.


4.Check for heat dissipation
To make it easier for the reduction gear box to dissipate heat. maintain its external surface clean and the ventilation holes clean. If the box temperature is too high, it need to checked to see if the oil level is too high. the surrounding heat dissipation conditions are poor. the oil quality is deteriorating, the cooling water is insufficient. and the cooling effect of scale in the cooling coil is poor.


5.Check for oil leaks
If oil leakage has found in the high-speed shaft. the oil level need to examined to ensure that it is not excessively high. If the shaft seal leaks due to aging or wear. you can inject suitable grease through the grease nipple on the cover. but if the leak is serious, the user should replace the oil seal on their own. Important note: after 8 hours of operation, the seal near a small region of infiltrated oil for not seeping oil. infiltrated oil area to increase the quality base for oil seepage. and accumulation of oil level leakage in the foundation.


6. Safety protection
The slewing part of the reduction gearbox with external leakage need to equipped with a protective cover. and grounded when connected to the motor or other electrical equipment. Important note: Please do not remove the test mirror cover during the operation of the reduction gearbox. to avoid personal injury caused by high temperature gear oil splashing.


7. Oil Change
During normal operation, metal micro-materials inevitably enter the oil . due to the continuous operation of the surface. These contaminants can shorten the life of the bearings . and lead to premature scrapping of the gear unit, so it maintained with the help of frequent oil changes.

Send Inquiry