Home > News > Content

How To Choose A Gear Reducer? How To Match The Three Major Parameters Of Torque, Speed Ratio And Installation Method

May 10, 2025

When selecting a Gear Reducer, the three parameters of torque, speed ratio, and installation method must be determined in combination with the equipment requirements. Let's talk about torque first, which determines how much load the reducer can carry. You must first calculate the working torque of the equipment during normal operation, such as the resistance of the conveyor line to drive the material and the torque of the hoist to lift the heavy object. When selecting, the rated torque of the reducer must be greater than the working torque. If the equipment often starts and stops suddenly, or encounters impact loads (such as the mixer encounters a hard block), it is best to leave a 20% margin for the rated torque, otherwise it is easy to damage the gear.
The speed ratio mainly depends on how fast you need the equipment to run. The speed ratio is the ratio of the input speed to the output speed. For example, if the motor speed is 1400 rpm, the speed ratio is 10, and the output speed is 1400÷10=140 rpm. If the equipment requires slow speed and high torque (such as a crane lifting heavy objects), choose a large speed ratio; if you need to accurately control the speed (such as a robot joint), you have to choose a model with high speed ratio accuracy. Note that the larger the speed ratio, the lower the transmission efficiency of the reducer may be. When running under high load for a long time, the heating problem should be considered.
The installation method depends on the structure of the equipment. Flange installation is to fix the reducer flange directly to the equipment with bolts. It is suitable for vertical installation (for example, the motor faces up and the output shaft faces down) and has good stability; shaft installation is to put the reducer on the shaft of the equipment without additional support, which is suitable for places with small space (such as the roller shaft of the conveyor belt); foot installation is to fix it on the frame through the bottom foot, which is suitable for horizontally placed equipment (such as mixers and fans).
After these three parameters are determined, look at the protection level of the Gear Reducer (for example, IP65 or above for humid environments) and the lubrication method (closed gear oil or grease lubrication), and you can basically choose the appropriate model.

 

Gear Reducer

Send Inquiry